WHX Miami 2026 "June 17–19, 2026 Miami Beach Convention Center, USA"
EUROSPINE 2026 "October 7–9, 2026 Gothia Towers & Svenska Mässan, Gothenburg, Sweden"
MEDICA 2026 "November 16–19, 2026 Messe Düsseldorf, Germany"
WHX Dubai 2027 "January 25–28, 2027 Dubai Exhibition Centre, UAE"
AAOS 2027 "March 3–6, 2027 Venetian Convention & Expo Center, Las Vegas, Nevada, USA"
2.4mm Y Adaption Plate in titanium, featuring 4 to 7 shaft holes and 3 head holes, with lengths from 38.4mm to 60.0mm. Supports 2.4mm cortical and locking screws. View sizes and catalogue references.
2.4mm Y Adaption Plate is a titanium plate in the StahlmannPro 2.4mm Hand System, available with 4 to 7 shaft holes and 3 head holes, with lengths from 38.4mm to 60.0mm. The specification table below identifies each listed configuration and its product reference, making it easier to match a quotation or replenishment request to the correct implant.
All holes are listed as supporting 2.4mm cortical and locking screws. The plate features compression and locking holes. Confirm the exact plate, screw and instrument combination against the applicable product documentation before use.
The adaption design is described as allowing bending in two directions and twisting to accommodate small-bone anatomy. Contouring must follow the applicable device instructions and instrument requirements; the catalogue does not give bending limits.
The catalogue lists fractures of the metacarpals, distal radius and carpals. These are catalogue indications, not a recommendation for an individual case. Suitability depends on clinical assessment and the current instructions for the specific device.
| Holes | Length (mm) | Titanium |
|---|---|---|
| Shaft 4, Head 3 | 38.4 | 4-406-04Ti |
| Shaft 5, Head 3 | 45.6 | 4-406-05Ti |
| Shaft 6, Head 3 | 52.8 | 4-406-06Ti |
| Shaft 7, Head 3 | 60.0 | 4-406-07Ti |
Send the selected catalogue references, quantities and delivery destination to StahlmannPro. Include any requirements for dimensional drawings, current device instructions and packaging information so the requested specification can be confirmed.
This plate is listed with 4 to 7 shaft holes and 3 head holes, with lengths from 38.4mm to 60.0mm. Use the specification table to match the required configuration to its titanium catalogue reference.
All holes are listed as supporting 2.4mm cortical and locking screws. Confirm the exact component and instrument combination in the applicable system documentation.
The catalogue lists fractures of the metacarpals, distal radius and carpals. The treating surgeon must assess suitability for the individual case.
The catalogue describes bending in two directions and twisting to accommodate small bones. Follow the device instructions for contouring limits and compatible instruments.
Provide the product name, hole configuration, catalogue reference, length, quantity and delivery destination. Include a separate quantity for each required reference.
