WHX Miami 2026 "June 17–19, 2026 Miami Beach Convention Center, USA"
EUROSPINE 2026 "October 7–9, 2026 Gothia Towers & Svenska Mässan, Gothenburg, Sweden"
MEDICA 2026 "November 16–19, 2026 Messe Düsseldorf, Germany"
WHX Dubai 2027 "January 25–28, 2027 Dubai Exhibition Centre, UAE"
AAOS 2027 "March 3–6, 2027 Venetian Convention & Expo Center, Las Vegas, Nevada, USA"
1.5mm Adaption T Locking Plate in titanium with 8 shaft holes and a choice of 3 or 4 head holes. Both versions measure 44.5 mm and support 1.5mm cortical and locking screws in all holes.
1.5mm Adaption T Locking Plate is available in two titanium configurations, each with 8 shaft holes and a 44.5 mm length. The choice is between 3 and 4 head holes, with a separate catalogue reference for each version.
This titanium T locking plate sits within the StahlmannPro 1.5mm Hand System. All holes support 1.5mm cortical and locking screws. When comparing this hand fracture fixation plate, check the head-hole configuration as well as the length, since the length remains the same for both options.
The catalogue lists proximal and distal extra-articular, partial articular and complete articular fractures of the hand.
| Holes | Length (mm) | Titanium |
|---|---|---|
| Shaft 8, Head 3 | 44.5 | 4-204-03Ti |
| Shaft 8, Head 4 | 44.5 | 4-204-04Ti |
State whether you require the 3 or 4 head hole plate. Reference 4-204-03Ti identifies the 3-head-hole model, while 4-204-04Ti identifies the 4-head-hole model. Use the table to match the requested configuration before sending an enquiry.
The catalogue lists proximal and distal extra-articular, partial articular and complete articular fractures of the hand. The surgical team must confirm the appropriate plate configuration for the individual case.
Both titanium versions measure 44.5 mm and have 8 shaft holes. Buyers can choose between 3 head holes and 4 head holes, each identified by a separate catalogue reference.
The catalogue states that all holes support 1.5mm cortical and locking screws. Confirm the required screws and compatible instruments as part of the complete system specification.
The version with 8 shaft holes and 3 head holes uses reference 4-204-03Ti. The version with 8 shaft holes and 4 head holes uses 4-204-04Ti.
State whether you require 3 or 4 head holes, then include the corresponding product code and quantity. Specifying the 44.5 mm length alone will not distinguish the two versions.
